EMC Accessories
EMC Accessories
10 kHz to 18 GHz | |
 | Detecting EMC trouble spots |
 | Measurement of magnetic field strengths to military standards |
 | Broadband active loop antenna for measuring the magnetic field-strength |
Broadband active rod antenna for measuring the electrical component of radiated EMI in test setups to MIL-STD-461/462 and similar MIL standards and CISPR25. | |
 | For disturbance voltage measurements on single-phase EUTs |
 | for RFI voltage measurements on three-phase EUTs |
 | For active antennas and EMI accessories |
 | for RFI voltage measurements at high currents |
 | Electromagnetic emission and susceptibility measurements in the range 5 Hz to 100 (200) MHz |
 | bidirectional, 0 Hz to 2.7 GHz, N (f)/N (m) connectors, load capacity 2 W, L section |
 | Log-Periodic Antenna |
 | Log-Periodic Antenna |
 | Log-Periodic Dipole Antenna |
 | Attenuator for ESH2-Z3 |
 | Log-Periodic Antenna |
ENVxxx to ESIB, ESPI, ESCI, ESU, ESL | |
ENVxxx to ESIB, ESPI, ESCI, ESU, ESL | |
Required to connect | |
 | For radio disturbance and immunity measurements on unshielded, symmetrical telecommunications ports |
| For radio disturbance and immunity measurements on unshielded, symmetrical telecommunications ports |
| For radio disturbance measurements on unshielded, symmetrical telecommunications ports |
 | For radio disturbance and immunity measurements on telecommunications ports |
 | Triple-Loop Antenna |
 | Active H-Field Measurement Antenna |
 | Low-noise Active Antenna System |
 | Biconical Antenna |
 | High Gain Log-Periodic |
 | Double-Ridged Waveguide Horn Antenna |
 | ULTRALOG |
 | The active voltage probe is used for measuring RFI voltages on lines that do not carry AC supply voltage. |
 | Active Receiving Dipole |
 | Active Receiving Dipole |
 | The passive voltage probe is suitable for measuring RFI voltages (on AC supply lines) to CISPR16-2-1 and EN55016-2-1. |
 | Measurement of disturbance power and screening effectiveness on cables. Reproducible measurements of disturbance field strength and disturbance power. |
 | Active Directional Antenna |
 | Handheld Log-Periodic Antenna |
for Active Antennas HFH2-Z1/-Z2/-Z6 and Test Receiver | |
for Active Antennas HFH2-Z1/-Z2/-Z6 and Test Receiver | |
N-type, common mode suppression | |
N-type, common mode suppression | |
for Test Antennas HFH2-Z6, HK116, HL223 and HUF-Z4 | |
Keyboards for FSEx, ESIBx (german or english) | |
4 HU, 7/8, for BW 2000 cabinets | |
For checking the interference source impedance to EN55016-2-1 and CISPR16-2-1 | |
 | High RF input levels and high-energy interfering pulses generated on artificial mains networks when the DUT is switched on and off can damage the RF input circuits of test receivers. The |
 | for interference measurements on vehicle antennas to CISPR25 |
 | For conducted emission measurements in the presence of high longwave mains disturbance signals |
 | Measurement of disturbance power and screening effectiveness on cables. Reproducible measurements of disturbance field strength and disturbance power |
The cables are highly screened for low radiated interference. |
Discontinued Products
R&S®HZ-11 E and H Near-field probe SetR&S®HZ14 Probe Set for E and H near-field measurementsR&S®HFH2-Z4 Inductive ProbeR&S®HFH2-Z1 Rod AntennaR&S®HUF-Z1 Broadband DipoleR&S®HZ-12 Precision Halfwave Dipole SetR&S®HZ-13 Precision Halfwave Dipole SetR&S®ESxS-K1 EMI SoftwareR&S®HK5000 AntennaR&S®HFU-Z_old Mast and TripodR&S®HZ-9 Power Supply UnitR&S®HFV-Z RF Probe, 20 MHz to 1000 MHzR&S®FS-Z15 Microwave Meas. Cable/Adapter Set ESIB26, FSP30, FSEM
